Especially unwanted when using long pitch bending, I play a note, keep it pressed, pitch bend and when I release (wanting the last pitch state to still sound during release time) the original note is played again. Noticed this with synth sounds, tried it with other instruments: same bad behavior: the bent pitch is not kept at release and is replaced by a brief note at the original pitch...
BTW are longer release times planned (5000 ms are very very short sometimes)?
Note played again at release
Damn, you're right! It
Damn, you're right! It isn't an actual retrigger, the pitch bend was just being reset to zero right at the release. Slow release sounds make it terribly obvious. I just fixed it here, thanks!
Sure, I can extend the max slow release on the control.
Sure, I can extend the max slow release on the control.